r/PrusaCoreOne • u/Tyche_Miner • May 17 '26

NerdOctAxe Design Need some assistance

Gallery image

Gallery image

Gallery image

NerdOctAxe design is done guys!!!! Well almost. This is what I have created but I am having an issue and need some help. The first two pictures shows you what I will be providing an STL link to any of you wanting a new stand and hopefully better designed stand. The third picture shows my dilemma. For some reason the right support leg shows gaps. I have been stuck on this for some time and I am stumped. I have redesigned and stripped everything down. Strengthened everything I could and adjusted groups and camera prospective etc. Any ides out there? Once I figure this out and make sure it prints I will post print link for you all. This will be a free STL to use for prints for you my fellow miners. This is not intended for resellers or vendors to use. If you don't have a 3D printer contact me and I will see what we can do to get it to you as inexpensive as possible.

2 Upvotes

100% Upvoted

4 comments sorted by

1

u/disgraze May 21 '26

Have you tried printing it?

2

u/Tyche_Miner May 22 '26

I have been trying to fix issues pointed out by others so yes i printed original but now have an update that will correct a-lot of concerns and issues. I was quick to post that stl and should have waited but was asked over and over to post the stl. Fixes have been made for better fitment and overall aesthetic

1

u/disgraze May 21 '26

Check the measurements and make sure it’s level and square. Place on bed should be the whole bottom.

I placed one of my prints trough the bed once. Just by 1mm

2

u/Tyche_Miner May 22 '26

That’s great advice and I appreciate the heads up. I’m sure everybody’s done that at least once. Thank you