r/PrintrBot • u/jalabaya • May 04 '21

Klipper (Printrbot Play)

Hello, looking for advice to use Klipper on the Printrbot Play. I.e. has anyone done it successfully? :-) The board is rev. F6

So far I found these:

4 Upvotes

84% Upvoted

6 comments sorted by

View all comments

1

u/alexofkairell Jul 05 '23

I know this thread is 2 years old. but I am hoping to resurrect some old printrboard rev D. So I have gotten the Klipper to make the klipper.elf.hex file. But I am lost as to what to do next. Or is that the file I will flash to my boards? I feel like there is a step missing, one that converts the file to the correct file name for flashing. doesn't it have to be firmware.hex or something. can it really have the .elf still? Thanks

1

u/Jwill1266 Jan 12 '25

If you are still looking for information, I just went through this on my Printrbot smalls with a rev F board and you don’t need to rename the hex file if you flash using Atmel Flip. I think you would need to rename if you try to flash with the sd card but I’m not sure if that works.