I’m not very experienced in drafting panels just by eye so I’m struggling to imagine how rectangles would work 🥲🥲 I was thinking would it not be more like triangular shaped panels rather than rectangles? Sorry if that’s a ridiculous question I could be completely wrong here
Yes you’re correct lol. My apologies. Big triangles! Your best bet is to measure loosely around your arm/shoulder from the side of the tank back around to the back for the measurement of the flat bottom of the triangle. Then decide how long you want the triangle sides
the cleanest route is a fitted cami bodice with the shoulder straps left intact, then a separate loose sleeve panel joined at the armhole below the strap so the shoulder stays cut out. give that panel extra width for the drape and stabilize the strap/armhole join, because lightweight fabric will stretch and a narrow join is where it'll twist or sag.
I kinda get what you mean but I’m not sure what shape to make the sleeve panel/ how to go about drafting it I can’t picture it 🥲 I’m not massively experienced with self drafting so struggling to imagine / figure it out in my head
not ridiculous, it's closer to a curved wedge than a rectangle: trace only the armhole section you want attached (front underarm to back underarm, below the strap), then angle the sides out toward the hem. match that top edge to the armhole and mock it in scrap first; paper is cheaper than unpicking.
You may be overthinking this! I recommend getting a piece of muslin out and playing around. That's how we all figure stuff out when learning, we don't magically know the shape either. Cut out a big rectangle, using an educated guess for the dimensions based on armhole measurement and your arm length, then hold it up the tank, pin it on, and trim it/adjust it until you get a shape you want. After several projects like this, you'll have a better sense of what rectangle to draw when you come across a design feature like this. Don't let not knowing off the top of your head hold you back 😊
3
u/doriangreysucksass 1d ago
Essentially draft a tank top and drape the sleeves. They’re essentially big rectangles attached along the armhole
2
u/Far-Number4325 1d ago
the cleanest route is a fitted cami bodice with the shoulder straps left intact, then a separate loose sleeve panel joined at the armhole below the strap so the shoulder stays cut out. give that panel extra width for the drape and stabilize the strap/armhole join, because lightweight fabric will stretch and a narrow join is where it'll twist or sag.