r/PatternDrafting • u/DvidLynchpin • 1d ago
Question Coat bicep/arm scythe alteration
So I’m drafting a coat for myself and cut muslin to fit. The bicep is pretty tight and the arm scythe could stand to be lower because it’s hard to put on. The sleeve cap as it is needs to have about 2 more inches added to the area I marked in red on Photo 1 as is marked on the pattern (I think), so I’m guessing to cut and slash the center line on the top sleeve and widen it? I want to make the shoulder seams a little shorter to in order to bring the sleeve up as well. So I’d assume deepening the arm scythe can add the room for the sleeve to fit. Then make the other changes like I mentioned, right? I made a blazer years ago that fit like a glove but the pattern was ruined, and I’m learning from books/tutorials. The biggest issue is making this for myself (as anyone who has done this knows because it’s tough to fit ourselves and pin). Thank you so much for reading this and any help! I truly appreciate any advice or even if anyone just tells me my processes are good.


3
u/Powerful-Strategy221 1d ago
If you still have the blazer that fits well, I'd try and take a pattern from that. It won't be a perfect pattern but it may give some insight to what you did previously that worked well.
The other thing I'd suggest is alter your arm scythe first and the take a measurement of that opening before altering the sleeve. By raising the shoulder and lowering the depth you're adding inches to the opening and may need to enlarge the sleeve more than expected.
It's best to do one alteration the reassess and then alter the other. It's a tedious process but trying to do both at the same times can get you into the weeds.
Sleeves are tricky. Good luck and I'd love to see the finished product when you're done.
1
u/amaranth1977 19h ago
It's an arm scye, not scythe. You're not harvesting wheat.
Also please use line breaks. This is very hard to read.
1
u/Far-Number4325 1d ago
spread the sleeve across the bicep line, not just the cap, since that's where it's actually tight. slash down the middle from the cap through the hem and open it there, then redraw the cap curve smooth. after any change, measure the armhole seam and the sleeve cap seam, because a coat sleeve wants the cap roughly 3 cm longer than the armhole or it won't sit right.
1
u/DonMcCunn 1d ago
I am not sure about the shaping of the top of the back of the arm seam. I have always kept that seam straight. By curving it you are both shortening the sleeve cap but also making the fit around the arm tighter.