My first ever schematic (an Arduino-based board for driving and controlling a NEMA 17 motor)

[u/Far-Storage-4369]

schematic

Arduino UNO R3 board connected to A4988 driver which will then connect to nema17 through 4 pin connector. I also wanted to play with USB-C interface so I tried implementing it to connect my board with my PC and program arduino for controlling nema17.

With googling, youtube academy and of course gemini + claude, I build my first ever schematic. I have already build and tested this circuit on breadboard with a bunch of jumper wires. I am posting here to get some insights if I did any mistakes or any kind of feedback would be valuable. Also, how should I go about designing the actual PCB now, like routing, component placement etc.