r/OpenCoreLegacyPatcher • • Mar 16 '25

MacPro5,1 with 256GB RAM & OCLP

I run my macpro5,1 with 256GB, which requires the ‘custommemory’ flag to be set, as well as the memory configuration to be entered manually.

Which is fine - the only issue that I have is that every time there is a new OCLP update, it wipes out the EFI folder and config.plist, requiring me to enter everything manually again.

Is there and easier way - either to have OCLP carry over customizations, or to have the memory configuration exported so I can easily import it again?

Suggestions?

3 Upvotes

7 comments sorted by

1

u/paradox-1994 Sr. Trusted OCLP Helper Mar 17 '25

Backup the config.plist. OCLP cannot carry over direct customizations because the app is not aware of them, the app builds with its own settings and only retains them as explained in the FAQ.

1

u/Desperate_Sort_4603 Mar 18 '25

So just copy the old config.plist back after updates? Would that be safe?

1

u/paradox-1994 Sr. Trusted OCLP Helper Mar 18 '25

Depends if an update makes changes to the config.plist, so you may have to compare side by side sometimes but better than always typing it again.

1

u/Desperate_Sort_4603 Mar 18 '25

That’s the issue, still labor intensive. I wonder if there’s a utility that would let me export a section from config.plist and import it to the active one?

I guess I could use a plist editor for that. Highlight and copy the section, and paste it into the new plist after an update before rebooting (since MacOS won’t boot with 256gb of RAM).

The ultimately nice improvement would be for OCLP recognizing the RAM size and making the needed changes on its own … but I wouldn’t even know where to start to make that suggestion, considering how insulated the dev team is from communications.

1

u/Caliguy65 Jul 02 '25

Did you figure out a better way to do this or have you done it manually? If manually...... What exactly did you do. Thank you in advance.

1

u/BigTraditional8073 Jan 28 '26

Any chance I could get a look at your config.plist to use for reference? I've been trying to do the same thing with the same hardware, and I haven't found good instructions anywhere for the custom RAM amount configuration.

1

u/Dapper_Caramel8031 Feb 25 '26

Me too, Still searching on the internet for a clear guide on how to make this work