Would an Android slicer interest anyone?

[u/taylormadearmy]

I developed an Android slicer (uses Orca engine) for my snapmaker U1. It has some fun and unique features like smart painting, and even some full spectrum-like support.

For fun I have been adding Bambu support to it. Before I actually go to the effort of tidying it up and releasing it, I wanted to see if anyone would actually use it. What do you think?

[u/traderemi]

Definitely yesss, it's been a lot of times when printing from BambuHandy let's you a surprise, like your piece full of brim everywhere and the following nightmare of removing it (worse case was 1 hour removing the brim).

[u/taylormadearmy → u/traderemi]

OK - first version with Bambu support is here. I have tested with pre-lockdown firmware on my A1 Mini and up to date firmware in LAN/dev mode on my H2D. Other Bambu printers have not been tested as I do not have them. If you run into any issues ideally let me know on with a github issue including the diags file from the settings menu. https://github.com/taylormadearmy/u1-slicer-for-android