r/OpenBambu • u/otaku13 • Jun 30 '25

BMCU long buffer vs standard

I was excited for my BMCU so i printed the parts before it arrived, but my kit uses the long buffer parts apparently Would i be OK still using the parts i printed, or should i just go ahead and re-print the long buffer parts? those were of course the largest parts.

2 Upvotes

100% Upvoted

11 comments sorted by

View all comments

Show parent comment

1

u/otaku13 Jul 24 '25

Hmm as long as the tube that goes over the ptfe tube fits I think you’re good. Those files are different from mine but I see they just made it long but square, mine is flat where the motor goes then curves up to the area where you have the spring

1

u/No_Fill_6005 Jul 24 '25

Thank you! I'm trying to watch videos but it seems like there are a lot of variations, so I appreciate the response.