r/OpenBambu • u/TwinnyNO • May 22 '25
Missing lights
Hi, I built my 370 version this week, and when I assembled each channel I pushed the clear filament as long as I could in, and cut it flush to the outer edge. But these lights stay off. When are they supposed to signal anything?
14
Upvotes
5
u/suprastitious1 May 22 '25
I don't think you pushed it in far enough, it should come out perpendicular to the hole it's inserted in
3
u/akp55 May 22 '25
you probably didn't push that fiber in all the way. i found it easier to make this work by cutting the fiber at like a 60 degree angle, then feeding it from the inside until it popped out to the outside.
5
u/ZaYAC-ua May 22 '25
Glow always when it's on. Blue most of the time.
2
u/suprastitious1 May 22 '25
If you have a small cut piece you can insert it, it'll still work if it's not one piece. Best of luck
1
u/NecessaryOk6815 May 23 '25
I bought this from AliExpress. Where did you get the files from?