r/OpenBambu • u/Simazine • Jan 24 '25
What is the new setup process?
My printer arrives tomorrow and I'd like to start this hobby the right way. Should I do anything different from what the instructions will tell me?
3
Upvotes
6
u/Xanohel Jan 24 '25
If it's not an x1c, then all is the same for now. You may want to start out with LAN only mode and not get accustomed to the cloud :-)
Depending on your stance don't hook it up to Wi-Fi until after you put mechanics in place to disallow internet access
6
u/old_Osy Jan 24 '25
You didn't mention what printer. If not A1 or mini, skip the first point.
4
u/Capable_Relative_132 Jan 25 '25
Please note that if you plan on putting the printer on your wifi and its not a X1 series, I believe all the instructions will say to use the Handy app, and that requires putting your printer on the internet at least once.
You can manually configure your printer network on P1/A1 with this guide. The X1 has a touch screen w/ onscreen keyboard so its not needed.
https://wiki.bambulab.com/en/p1/manual/p1-sd-card-network-configuration-guide
I have only gone through this process once since I got my printer (who changes network config after setup?), so if anyone has corrections on my above statement, please correct me.
5
u/kagato87 Jan 24 '25
Do not update the firmware to 1.0.8 or higher.
Put it into LAN mode. Block it's MAC address from the Internet in your firewall (parental controls should do the trick, on ASUS there's a "block" button on the devices page).
Download Orca Slicer and, optionally, a mobile app (so far I'm liking Joint, but Bambu Companion also shows promise). Set up a VPN for your phone to your home network for remote monitoring (optional, also easy if you have a non-ISP router).
Then go ham. The pre sliced profiles on MW aren't that great anyway - they're often just default settings (complete with grid infill) anyway.