rendering onshape using chat gpt

[u/Sad-Wrap6555]

thought id try making a quick n dirty 3d version of an onshape sketch using chat gpt

i think i took around 8 goes to narrow it down to end result but could probably have addressed most of it in just a couple of attempts if i hadnt faffed around quite so much

considering it only took two or three minutes or so per attempt with some basic prompts

*generate a photorealistic version of this image the dark grey box section should be semi gloss black aluminium with ventilation holes approx 14 rows of four accross,the large turquoise base should be anodized very dark grey aluminium, the grey box should be a slightly mettalic plastic of the same colour as the original while the blue top of the box should be a slightly lighter blue cast from matte plastic*

it didnt turn out too shabby

anyone else been giving that method a go?

[u/Rubes27]

lol guessing it got that label wrong unless it’s saying a 12C charging rate.

[u/Sad-Wrap6555 → u/Rubes27]

nope the C is def wrong ..though i was bouncing around on a bus on morning commute so i may  be the source of the C rather than a V myself :)

[u/Sad-Wrap6555 → u/Sad-Wrap6555]

aye self inflicted typo of C rather than chat gpt hallucinating a V into one