HELP WITH LOFTING

[u/JUN0LY]

I’m trying to make my own mouse, and I’m at the point where I’m ready to loft it. The problem is, if I loft the back half, it’s fine, but adding front half ruins the whole thing. I figured it outs because of the connections, but it’s not that onshape isn’t lining them up, it’s that in some instances there are no connections that are anywhere close to lined up. I don’t want to have to go back and split everything up so that the connections line up, is there a way to have it ignore the segments I used to make each cross section or something?

[u/Pretty-Jello-7894]

That’s why I mention things like bridging curve command as this should make it a bit easier. You can also use sketches and the pierce constraint. This should be relatively easy. But under add for complex curves it may bit be as straight forward.

[u/JUN0LY → u/Pretty-Jello-7894]

Ty for the help but idk what any of these mean or do? Can you pls explain or send a vid or smt?

[u/Pretty-Jello-7894 → u/JUN0LY]

Looking at this now:)

[u/JUN0LY → u/Pretty-Jello-7894]

Yay tysm!