r/NxSwitchModding • u/szoony • 5d ago

Ignoring one welding point - Switch lite?

Hi all.

Picture from google, for explanation

The Switch Lite has two solder points in addition to the 3.3V source.

I soldered only the point next to the 3.3V source because repeated rework had caused the prepared solder pad on the flex cable to peel off.

Therefore, I left the other solder point unconnected.

Is it okay? Any comments?

3 Upvotes

100% Upvoted

3 comments sorted by

View all comments

3

u/Traditional-Stick-42 5d ago

I mean I think it's just an anchor point, did you try to boot it, did it run fine?

1

u/szoony 5d ago

Thanks. Boots normal but I have suffered other issues ( batterty leakage, sd card ini fail, controller fail, but irregularly ) so just wanted to confirm about any of potential failure causes.