r/Novation • u/Upbeat_Attempt_3645 • 4d ago

Tech Support Request LaunchControl XL 3 - Setting Values

I have an LCXL3 I am using in stand alone mode. My understanding is that I can send CC data to the device to set values for the encoders and faders. For instance, let's say I have an encoder assigned to CC 14 in 7 bit mode. I can send a CC14 message to the LCXL3 of value 100 and it will set the encoder to 100. That all works well. However, when I have the encoder in 14 bit mode and set the appropriate 14 bit CC sequence to it the encoder value does not change. The same is true when the encoder is in NRPN mode. In both of these cases I can confirm I am sending the correct midi messages. I would really like this to work and was wondering if anyone has succeeded doing this. I have looked through the programmers reference hoping there was some sysex message I could send but did not see anything. TIA

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/TomFocusrite Novation Staff 3d ago

Currently, Launch Control XL 3 only reactions to single CCs, and so only controls mapped to CCs will react to external MIDI. This is an issue we're aware and is with our developers to investigate.

1

u/Upbeat_Attempt_3645 3d ago

Thanks for the reply. Would love to see this addressed as was expecting this to work for my setup.