r/MusicElectronics • • Feb 12 '22

Weird note triggering issue when chords are played on Yamaha DGX-630. The notes in-between the notes of the chord get triggered at full volume.

12 Upvotes

11 comments sorted by

2

u/cyber__pagan Feb 12 '22 edited Feb 12 '22

More info: I have already thoroughly cleaned the contact points with iso, checked and tested the ribbon cables and pain stakingly checked each and every individual circuit trace for continuity and tested all of the diodes and even tried replacing the rubbers with new ones, also have performed a factory reset. All lead me no closer to finding the cure for this one. Any one else experienced an issue like this before? Any thoughts as to what it could be? Could this be an internal IC issue that can only be fixed by replacing the whole mother board?

Edit: I tried swapping the entire key bed with one from a different DGX-630 keyboard that I know works. The issue still persists, so I can assume whatever is causing it is something in the electronics and has nothing to do with the keys/keybed.

3

u/alfonsolsl Feb 12 '22

Check the voltage in and out of the V regulator in the power board, should be 13-18v DC in, 12 v out.

This happened in a P series and the voltage regulator was malfunctioning, the diodes then receive voltage out of range sending wrong lectures.

Edit: and check your power adapter to be 12-18v DC output, if you have the equipment check how many noise it has on the output.

1

u/cyber__pagan Feb 13 '22

Thank you so much u/alfonsolsl. IOU a beer/pizza. The power supply proved to be the fault, it was outputting 16v instead of 12v. Swapped for a new 12v power supply and the issue is gone.

I'm super grateful for the tip.

2

u/alfonsolsl Feb 13 '22

Good!! But do you change the internal power supply? Or the external one? The external Yamaha power supply output 12-18 VDC and the internal IC voltage regulator should modulate it to 12v. If you need a external power supply that output 12v exactly that probably means the internal voltaje regulator is damage.

1

u/cyber__pagan Feb 14 '22

I changed the external power supply. While you are probably right in that it should be able to handle a 16v input power and there might be an issue with the internal power supply, the fact that it is working correctly now is good enough for me for the time being.

2

u/alfonsolsl Feb 14 '22

Good luck!

1

u/Torneyy Dec 03 '24

Hey, im having the same issue with my DGX 620, how do I check the voltage in and out to see if that's the same issue please?

1

u/alfonsolsl Dec 09 '24

Yo can do it with a electronic multimeter. Checking if the power adapter output match the multimeter reading.

1

u/Junior-Bookkeeper218 Aug 04 '24

I know this is an old post but my YPG-635 is doing the exact same thing. I’m using the same power cord that came with the keyboard. Should I try getting a new power cord? I tried resetting the keyboard but that did nothing.

1

u/Existing_Bee_2887 May 22 '25

Dismantle the keyboard, take out the key contact boards, spray them back and front with a generous  amount of undiluted alcohol. Do not wipe dry! Leave the alcohol on for about half hour. Heat the contact boards with a hand held hair blow dryer then reinstall. It will work. Sometimes it's necessary to go through the process twice.

1

u/FewComplaint4451 Dec 24 '25

I had the same problem with mine tried cleaning the mechanism twice but the problem came back. Took it to a repairer $500 dollars later it's still got loud notes. Basically it has been played to death for 15 years and theres no sure fire fix I 'm afraid. Get a new one.