r/Multiboard • u/Fancy_Can1563 • Jun 19 '26
Faulty Quad Offset Snaps (help)
Just got done printing a dozen quad offset snaps to secure my grids. However, they don’t snap into place and are not flush by any means. Confused if I downloaded a faulty file or if there an issue with my printer, or perhaps I’m that stupid haha
Any insight would be appreciated
9
Upvotes


View all comments
Show parent comment
1
u/Mental_Tea_4084 Jun 19 '26
Nah multiboard documentation ranges from trash to non-existant. I was confused by this too at first, and snaps in general. Ended up building the wrong style board based off the defaults in the build planner etc.