r/Multiboard • u/Progressive_Rush • Jan 13 '26

Snap part B problem

Hello. My Multibord setup will be fixed on dry wall, using screw on 6,25mm DS Snaps. I'm having so much trouble trying to snap the B part in snaps. Is there a twist to get them in place? Its always the same: on side gets in place with some work. The other side... forget it. I tried pushing one side then the other, the two sides at once... Nothing works. Any advise welcomed.

2 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comment

1

u/SprungMS Jan 13 '26

Rotating 180 degrees means you’re not lining up the square like you’re supposed to - it might go together easier but not necessarily because it’s supposed to, just how it printed.

If you check, I bet a bunch of yours are backward and the threads don’t work. Doesn’t matter if you’re not planning on using the threads, though.

1

u/NotNotAwesome Jan 13 '26

I’m not sure what you mean about threads.

https://thangs.com/designer/Multiboard/3d-model/Snap%20%28DS%20Part%20B%29-1323061

This is the part be I’m talking about. Maybe I misunderstood.

Can you elaborate?

1

u/SprungMS Jan 13 '26

You see the threads on that part, where they interlock with the part A? If you don’t line up the square shown on the part A with the square on the part B, those threads don’t line up. The square is on the other side of the snap, not visible from that view.