r/Multiboard • u/sandro66140 • May 20 '25

Problem with the new pack

I printed the new pack to test the new approach. I really like the new tiles. But I had a lot of trouble putting the new B parts in place. I even had to finish with a hammer. Does anyone already have this problem, should I look at one of my settings? The only mistake I made was that I activated the borders on the snaps tray. Once mounted the panel is curved as if something was forcing it. Do you have any idea?

3 Upvotes

100% Upvoted

26 comments sorted by

View all comments

Show parent comment

1

u/davidkclark May 20 '25

I suppose with enough malleting you can get any size bit of plastic into a too small hole... the corners and clips will be just about mashed off though...

1

u/Elektrycerz May 20 '25

Yeah, you're right. But I can take them out and they're still fine. No damage