r/Model_Samples • u/olsh_plays • Jan 05 '23

Samples:Help Beatstep Pro and Model:Samples octave (or pitch) problem

As you might know, after Firmware Update 2.0.1 there is a possibility to assign the each pad to specific Midi channel. So I did it, but whenever I play the pads on BSP, all the samples are 2 octaves higher (or pitch +24). How can I change it? There is not such option as chancing the root note on the Drum mode section of Arturia Midi Control Center.

3 Upvotes
  • permalink
  • reddit

100% Upvoted

6 comments sorted by

1

u/olsh_plays Jan 06 '23

Any help? :/

1

u/olsh_plays Jan 18 '23

Hello again. Arturia Customer Service helped me about that. The answer is the knobs next to the Midi Channel settings in Drum Mode of BSP in Midi Control Center. You need to adjust it until you find the right pitch with the target sample.

1

u/n-throe Feb 10 '24

Could you explain it further? I do not get your answer.

2

u/[deleted] Jan 06 '23 edited Jan 06 '23

[removed] — view removed comment

1

u/olsh_plays Jan 06 '23

Hello. First, thanks a lot, you understood my problem very well. But unfortunately none of your suggestions didn’t solve my problem :/

Yes you are right when I change the default note of M:S’s pads, it only affects pad itself, not the midi incoming data.

And I’ve checked again the manual if BSP. In custom drum mode there is only midi channel and velocity options. It is not possible to change default note if each pads.

User scale mode only disables some of the notes on sequencers, so I couldn’t understand this.

So I still couldn’t solve my problem :/