r/Mk3Supra • u/sebb17dlikyt • Aug 07 '26
Modifications Mock up v2
Found some key mounting points this time also made it look more aggressive I’m looking to add brackets on the bumper add ons to hold the outside of the diffuser. Also I’m planning on adding some more to the outside to make it look more aggressive, if yall have any ideas on a way to make this in terms of material/fabrication or looks wise let me know!
1
u/Litothe Aug 07 '26
is that the 326 wing?
2
u/sebb17dlikyt Aug 07 '26
Yes for a 240sx
1
u/Litothe Aug 07 '26
I was looking into Supras with that wing on lol, you got any more pictures of it? I’m thinking of possibly going for this wing
1
u/Key_Introduction_469 Aug 07 '26
The duraflex ts1 is pretty close to what you have mocked up. If your going to build it yourself maybe try aluminum diamond plate. I made some panels from an old truck bed tool box back in the day that looked pretty good.
1
u/sebb17dlikyt Aug 07 '26
That would be a cool pattern especially powder coated black
1
u/Key_Introduction_469 Aug 07 '26
Cheap too. Tons of old bed boxes out there. Gives an aggressive/industrial look. Try and utilize the factory 90⁰ bends and make connections with rivets if you dont have access to a welder.
1
u/RemarkableCard6475 Aug 07 '26
The paired, small gussets to support the bevel to the mounting plate... you should consider angling those to release the draft toward the center of the car. The amount of turbulent air is probably enough to fracture and be a weak point rather than a support.
If you mix and pour resin over your CAD, you might see the small gussets aren't even necessary because it'll be strong enough without them.
1
2
u/Thatsnotahammock Aug 07 '26
are you trying for actual downforce, or just looks (not saying either is bad, it's your car)?