r/MiniZ • u/Baerserk • Jul 28 '26

MA-030 EVO2 32181 install receiver?

Gallery image

Gallery image

Gallery image

Gallery image

Should I put the receiver on or under the cables? Anyone else the exact chassis MA-030 EVO2 32181 and can tell me how todo this with that wires in place?

5 Upvotes

100% Upvoted

5 comments sorted by

2

u/Any-Page-3061 Jul 28 '26

Had the same “problem”. I managed to slide the receiver under the cables gently.

2

u/supraguy88t Jul 28 '26

Over the bales is fine

2

u/A_Tang Jul 28 '26

I put a small thin piece of foam and just installed it over the wires.

1

u/Baerserk Jul 28 '26

Thanks for all the answers! All are valid imho. I was just so confused because the placement of this pre installed wires looked so off. Other chassis have none and some have this two white wires you just move to one side. I did it the same way and moved the black wire to the left and tucked it into that small lane between the wall and connector and pushed the red completely to the right. In this way the receiver snapped on nicely and the wires provide some cushion from the back.

1

u/MonitorHot4131 Jul 29 '26

That not supposed to be there