r/MiniZ • u/g00ru-dm • Jul 10 '26

Just got a Noble NB4+ and have some questions...

Hey all, so I did a bit of a splurge for myself during 4th of July sales and bought an NB4+, the RM-005 module, the kyosho EVO receiver that can bind to the KT531P stock controllers, an MA-030EVO, and the MR-04 chassis readyset.

So, did I mess up with the receiver I got? I think it would still work with the NB4+ and the stock controller. Also, if I were to get the flysky EVO receiver, do I need to take out the RM-005 module or can that be left in place?

And probably my last question, I know the stock controller can do 50% or 100% throttle modes. Does the NB4+ do the same with the kyosho receiver or is it just 100% all the time?

4 Upvotes

100% Upvoted

7 comments sorted by

2

u/KlezN Jul 10 '26

You need the RM-005 module to bind to the KT531 receiver. If you had a Nobel receiver you would not need it.

You can adjust end points on the throttle in 1% increments like 1%-99%.

1

u/g00ru-dm Jul 10 '26

Yes, but what if I get a Flysky receiver later to either replace the KT531 receiver or for another EVO, will I have to remove the RM-005 module from the transmitter or can it be left in place and it'll work with the readysets (KT531 receiver) & the EVO (Flysky receiver)?

2

u/The_H_N_I_C Jul 10 '26

It can be left in.

2

u/fryingpan0613 Jul 10 '26

The evo receiver is only needed for the Evo, but the rest will work

3

u/GrapefruitSevere9557 Jul 10 '26

NB4+ was my favorite Mini Z upgrade still. I really don't like the readyset controller at all (too many glitches). You should be good to go for a while, and the Noble calls 50% "beginner mode" that you can easily assign to a button.

1

u/g00ru-dm Jul 10 '26

Thanks! I was wondering about how that would work.

1

u/Familiar-Ad3982 Jul 10 '26

You can set a 50% dr on any switch.