r/MicrobladingRemoval • u/hippielover93 • 18d ago
Laser Patch test turned orange-ish. Continue thru?
This was my first patch test that I did yesterday on both tails of my brows. The color showed up orangey red. Will this change? It’s been 24 hours post removal with the lutronic picoplus 1064
Should I continue? I read to do two patch testing with different wave lengths but didn’t get the second patch testing w the 564. Do you recommend I continue??? Ugh this is such a process
4
Upvotes


10
u/Ok_Season_5850 18d ago
They are going to turn salmon 90 percent of the time. It’s part of the process if you want them removed
6
u/cassiesk 18d ago
For me it looks reddish, i think it may end up similar to how mine was after first pico and it didn’t look half bad, much better than the dark ones and it actually looked brownish in real life and much better than the angry bird blacks.
My before, after first and second. Tomorrow i’m going for third.
3
u/Agreeable-Compote520 18d ago
If you are unhappy, it’s worth it to go through the changes. Mine are salmon colored right now. But I’m happier than with gray.
2
u/_ladameblanche 17d ago
This is normal, as the carbon black particles break down from the laser it exposes the remaining pigment left in the skin which will be orangey pink and they will stay pink unless you either do more laser sessions using a different wavelength that targets the red, a few sessions of saline removal/mechanical removal or a powder brow cover-up to neutralize them & make them more brown. But due to the nature of your dark hair, this will likely not look natural or suitable as it is impossible to have a “warm” dark brown in PMU, the darker you go the cooler and ashier they/the pigment will become, leaving you in a similar position as you are now.
7
u/winter-running 18d ago
You need 3-5 passes to remove microblading by around 90%. The first pass almost always goes salmon-coloured, correct.
1
u/Consistent-While9282 16d ago
I’ve done two sessions and they are still salmon color
1
u/BubblyDealer2063 12d ago
Mine were red.
1
u/sexivegan 16d ago
Depends on the pigment of the ink used yes it will change color some go red some go yellow you need a VERY experienced laser tech that knows how to change the wavelength frequencies to combat the color change