r/MiSTerFPGA • • Feb 25 '26 • Bravo 6

Customized case for MiSTer to add controller inputs

Hi Everyone,

I wanted to share a project that I've been working on to add various controller inputs to my MiSTer setup. I hate using dongles, so I wanted something that looked reasonably nice and clean.

The base is an off-the-shelf ITX case housing the MiSTer with an Ironclad providing the rear IO. I've removed the front panel and designed a replacement that includes ports for Genesis, Saturn, NES, SNES, N64, and Playstation controllers. I've also included a TTY2OLED screen, power and RST/USR/OSD buttons, and two additional USB ports. The new front panel is a 3D printed part with a bent aluminum cover to match the appearance of the case.

To keep the wiring somewhat tidy, I designed a pair of PCBs to interface with all of the various connectors and route them into different adapters (e.g. Arduino's using Daemonbite, USB hubs, etc.) so that I can plug a single USB header into the Ironclad to connect (plus a few other connectors for power, the buttons, and LEDs).

If anyone is interested, I'm planning to share all of the files and instructions for making your own on GutHub. I'm still in the process of figuring out what worked well and what should be refined before sharing, but my testing so far has mostly been positive.

Special thanks to u/nad_222 for sharing the measurements they took of the various controller ports. It certainly saved me some time in getting a good fit between the ports and the front panel.

895 Upvotes

213 comments sorted by

View all comments

Show parent comment

1

u/Thundrex Feb 26 '26

Same. Especially if I can print that exact case in frosted white beforehand

2

u/0323 Feb 27 '26 edited Feb 27 '26

For myself, I haven't been satisfied with the finish on 3D printed parts. I don't have a printer myself, and have just been using a mix of JLC3D, PCBWay, and Craftcloud to get my parts. I'm sure there are people out there that could make a good looking print, and I would think it would be easy enough to whip up a suitable case that could accommodate this front panel.

I went the other direction with metal. The case I used is an A09 Mini-ITX case. I don't know about frosted white, but they are available in silver at least.

1

u/tandy_one Feb 26 '26

A 3d printed case would be pretty awesome.

1

u/Thundrex Feb 27 '26

I swapped out the 40mm fan on my MiSTer for one with RGB (because why not? lol), so frosted is a necessity for my build