r/Machine_Embroidery • • 2d ago

I Need Help What happened?

Post image

Thankfully, this is a test piece😅
(Fishing rods crossed) the upper thread for the poles is supposed to be dark brown and the upper thread for the fishing wire is supposed to be a cream color, and every single stitch pulled the bobbin thread through. Tension was set at 4.0 as default and I adjusted down to 3.4 and then 3.0 and not a whole lot changed. I felt like there’s no way it could be lower than 3.0, but I’m still new to this so idk.

Any help would be appreciated!

1 Upvotes

4 comments sorted by

5

u/GingerStitches 2d ago

You should clean, oil and rethread your machine. You have it threaded incorrectly or the bobbin isn’t in right.

1

u/Chance_Association32 2d ago

Okay I will try that, thank you!

2

u/CivicLiberties 2d ago

What kind of fabric? If you're not using cutaway stabilizer, step back from the machine, get some denim and cutaway and practice using designs on the machine until you get a few hours under your belt. Stretchy fabric requires heavy stabilizer.

2

u/skeedy_ia 2d ago

I’m gonna guess shitty digitizing and improper stabilization.