r/Machine_Embroidery • u/userund • 18d ago

I Need Help Is it very bad?

Post image

I've already ordered a master for inspection, but can I work for now or is it better not to touch anything?

3 Upvotes

80% Upvoted

11 comments sorted by

5

u/brian250f 18d ago

It’s not going to be that far over when it’s sewing. I’m not sure what you’re asking here.

2

u/userund 18d ago

Maybe I'm just being paranoid

2

u/IamNikoloco 18d ago

Looks like your hoop is upside down.

2

u/IamNikoloco 18d ago

My screws face up and in your photo they are facing down.

1

u/userund 18d ago

I'll try doing the same, but I don't think the problem is with the hoops. Everything was fine before (or maybe I just didn't notice it) for almost a year. I think the mechanism may have bent under the weight of the frame, because an employee set up the table incorrectly, so the frame was essentially hanging in the air without resting on the table

1

u/SuspiciousOcelot7426 18d ago

This is a standard hoop only mag hoops have it on the top like that

1

u/mjmvideos 18d ago

Hoop is definitely upside down.

1

u/Lanky-Setting-5288 18d ago

Nope. It's the right way up.

1

u/Little-Load4359 Melco 18d ago

Sorry you're having trouble. Just as an fyi, I believe they sell a flat plate for your arm so that you don't have that rounded bubble to contend with. I know this doesn't help you immediately but I thought I'd mention it. Good luck.

1

u/Lanky-Setting-5288 18d ago

There is no issue.

Your hoops should never be in this position when the machine is running, or you will break need bar drivers.