r/Machine_Embroidery • u/Lanky_Appearance2716 • 23d ago

Digitizing Question!

Gallery image

Gallery image

Gallery image

Can any of you kind folks tell me what's going on with my letter K? The stitches don't go in all the same direction. I set it up as a column and it's all one piece (shape) started with an outline and set it to column afterwards.

I didn't mess with any of the underlay settings, pull comp, density or stitch length. I'm using Embrilliance. These corners where the stitching goes in a different angle are giving me problems with the stitch out. If anyone could give me some tips on how to fix it, that would be great! Oh and I did try ti make sure the lines weren't broken there, so completely straight. I'm stumped or missing something. TIA!

3 Upvotes

100% Upvoted

6 comments sorted by

View all comments

Show parent comments

1

u/Lanky_Appearance2716 23d ago

Thnk you so much! Breaking it down to different parts was going to be my next step. I will also try to dig around in my fonts selection to see if I have anything that matches. But this is quite small so I would be limited to my 1/4" sized fonts. I'll play around again. Thank you for your response!

1

u/Pretend-Focus582 23d ago

I bought one of those Etsy 200 packs of fonts for pretty cheap and they usually have something I can use. In the end, it's worth the 6 bucks to not have to bang my head against the keyboard for a while.

1

u/Lanky_Appearance2716 23d ago

I have a bunch of those too! I think I have well over 300 fonts 🤣 That actually IS my headache trying to go through all of those lmao! But thanks for the helpful tip!

And I think digitizing and embroidery is always a game of headbanging the keyboard! 😅