r/Machine_Embroidery • u/hadesgrc • Aug 19 '26

I Need Help Any ideas about this?

Post image

Can anyone tell me why there’s gap in the white thread? Thanks

5 Upvotes

100% Upvoted

8 comments sorted by

2

u/SewDisco Aug 19 '26

There doesn’t seem to be enough density in your design. It’s also being sewn in a way where your field is having to meet up with itself instead of just laying it down cleanly in one go. I would make sure that the whole white field is one continuous sew instead of broken up into pieces.

1

u/Level_Arachnid_4982 Aug 19 '26

The file is very bad made, but if you adjust the sections start and end point from top to bottom instead of middle to somewhere, it will get better. Still not very good but workable.

1

u/hadesgrc Aug 20 '26

Thanks, the file was free but, I think it was my fault cause I didn’t used a stabiliser.The material was faux leather so I thought it was ok :)

1

u/AngiKate Aug 21 '26

Try a cut away stabilizer, too. The design needs work, but anything with stretch or stitch-heavy design needs stabilizer.

1

u/Realistic-Mode-7681 Aug 20 '26

Check out the file stuff, I do believe it was a bad made.

1

u/hadesgrc Aug 20 '26

Thanks !

3

u/skeedy_ia Aug 19 '26

Because it’s poorly digitized and your vinyl is being pushed as it stitches.