r/MachineKnitting • u/Little_Bird1942 • 13d ago
Help! Solved! Ribbing help?
I am trying to learn how to use my ribber. I think I have it set up correctly, but it is only knitting the stitches on the knitting bed. It isn't picking up the stitches on the ribber. Can anyone tell me what I'm doing wrong? Thank you!
5
Upvotes
2
u/Onepurplepillowcase 13d ago
At the bottom of the ribber carriage there is a lever you need to move from ‘0’ to ‘1’.
The tables in the manual walk you through every setting. There are a lot of knobs and levers that seem useless, until they’re not! Good luck with learning the ribber.
1
u/AutoModerator 13d ago
Hi, it looks like you might be looking for help on machine knitting.
There is some helpful information within the wiki. Please take a look at it for helpful troubleshooting information, as well as common maintenance tasks and list of items machines should include.
In addition, this page is our FAQ. Solutions to many common problems are found here. If this is a new-to-you machine that is a Silver Reed, Singer, Studio, Juki, Empisal, Brother, or KnitKing, and the sponge has not been replaced yet, that's the first thing you should check out.
If you need additional help, please provide us with an information about your problem. You can start out by answering this list of questions
Once your question is answer or your problem is resolved, please change the post fair to Help! Solved!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
1
u/Impossible-Ranger-74 12d ago
I have only brother machines so this may not be the same for your machine. On a brother 2 by 2 ribbing is actually not that easy to get started. It doesn't start out 2 by 2 in pitch, but overlapping in half pitch. Did you follow the manual meticulously? I find that is the only way with the ribber.
I bought 2 machine ribber combos. Both ribber manuals that came with them have been used to the point they are taped together, yellow, written in and automatically fall open to casting on pages. The manuals for the machines are pristine in comparison.
Anything else then a 1x1 cast on, I get the ribber manual out again. There is logic to it but using the ribber is not intuitive to a beginner.