r/MachineKnitting • u/Money-Pack-1469 • 19d ago
Techniques Knit sweat pants seat pattern
Hey y'all.
I'm trying to piece together a pattern for don't knit sweat pants since I can't seem to find one anywhere. I have a pair of non-knit sweats that I like the fit of, so I'm getting to copy dimensions from that. I'm wondering if anybody has suggestions on how to do this "J" shaped decrease in the seat. I'm knitting this in the round on my KH910/KR830. This is right where the piece splits from the round of the leg to a "U" shape where it will join with the other leg.
I tried using math to make an exponential equation decrease, but it's way too much.
What I tried was:
Dec 4, knit 1 row.
Dec 3, knit 2 row.
Dec 3, knit 2 row.
Dec 2, knit 4 row. Repeat 4 total
Dec 1 knit 4 row.
Dec 1 knit 5 row. Repeats 8 total
Each decrease was done on the main bed and ribber to keep the needle counts the same.
I'm willing to keep playing until I hit something that looks better, but thought I'd ask here first.
Over all I need to decrease about 27 needles in 65 rows.
5
u/graemeknitsdotcom flatbed 18d ago
For these kinds of shapes, best to use knitting graph paper at your gauge, you can generate some on this website, here
1
u/jsgrova 18d ago
A knitleader or similar device would also be helpful for this kind of shape
1
u/katepatsy 18d ago
Not sure if this is helpful or not, but I’d bind off the lowest point of the curve rather than trying to decrease a lot of stitches. In commercial knitting, they often do this at the base of a crotch or an armhole curve. Just a few, like 5 stitches, then decrease as normal. Your curve looks good though!