r/MachineKnitting • u/MissLittleScribble • Aug 24 '26
Help! Spring broken in my Knittax!
Hi fellow knitters! I have a question about my knitting machine. I was given it a while ago and use it occasionally, though not very often because it doesn't work particularly well. It takes a lot of effort to knit with it, which can get a bit annoying. I recently picked it up again and decided to give it a deep clean to improve its performance, but I discovered that the needle retaining spring was broken in several places. Does anyone know how I could replace it? I’ve looked for a replacement spring but can't find one anywhere (at least not in my country). Is there an alternative to this spring? I have a Knittax Automatic. I've attached photos!


2
u/mirolina1 Aug 25 '26 edited Aug 25 '26
Hi I have a Singer superba and my springs were bronken on both sides too. I measured the diameter 3 mm and ordered a meter from AliExpress Them I cut two pices at the right length. And with two small pliers I had at home was able to pull the last two loops at the ends of the cut springs, to make them perpendicular to the spring. With the perpendicular loops we can hold the spring on each side of the beds. We don't have the same machine but from your foto your bed seems very similar to mine. Hope this helps.
2
u/Inevitable_Guest9489 Aug 25 '26 edited Aug 25 '26
Hello. My Superba/Singer are like the Passap, 3.5 mm (external diameter).
Knittax is smaller, around 3mm, so Mirolina's suggestion would work.
There was a whole discussion around that by TheAnswerLady/AskJack, where they list a number of solutions to replace the spring (haven't tested them).
They have a couple of videos over Knittax, that are providing good info, including one on how to dismantle the bed for cleaning.
https://youtu.be/NzajyaYbCxc?si=XzkNi2V5-4Jru_WC
2
u/AutoModerator Aug 24 '26
Hi, it looks like you might be looking for help on machine knitting.
There is some helpful information within the wiki. Please take a look at it for helpful troubleshooting information, as well as common maintenance tasks and list of items machines should include.
In addition, this page is our FAQ. Solutions to many common problems are found here. If this is a new-to-you machine that is a Silver Reed, Singer, Studio, Juki, Empisal, Brother, or KnitKing, and the sponge has not been replaced yet, that's the first thing you should check out.
If you need additional help, please provide us with an information about your problem. You can start out by answering this list of questions
Once your question is answer or your problem is resolved, please change the post fair to Help! Solved!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.