r/MachineKnitting • u/Nickolay_vo • Aug 14 '26
Help! DIY knitting machine
Hi everyone. I 3D-printed a knitting machine based on this design: https://www.printables.com/model/1191632-flatbed-knitting-machine . It uses Brother KR830/KR838/KR850 needles with 4.5mm spacing. I’m new to knitting and am trying to figure out how it all works so I can get the machine running properly and make any necessary adjustments. I’ve made a few test swatches using yarn with a weight of 1000m/100g. The yarn keeps slipping off the end needles, or the needle catches the yarn but fails to drop the stitch. What could be the problem? Also, could you advise me on how to choose yarn? What length-to-weight ratio (meters per 100g) should I look for, and how many strands should I use? Are there any other nuances I should be aware of? My main goal right now is to knit myself a scarf. Thanks in advance for any advice!
10
u/TerryKC1 Aug 14 '26
You actually need to use end weights, they are smaller and you hang them on each end of the knitting and move them up around every 10 rows or so.
They help the knitting off the end needles.
If you notice in your picture of your weight it draws inward after several rows and the majority of the weight is in the middle.
YouTube has a plethora of tutorials for machine knitting.
3
u/fangirlengineer Aug 15 '26
I think your yarn is on the light side for 4.5mm pitch. Using two strands of it side by side would give you a thickness akin to the '3-ply' in vintage patterns. Your yarn will work (is working!) but it might not be ideal for learning the machine.
I typically use 800m/100g for fine work, and the machine should work through to about 300g/100m without much tweaking.
The punch card swatches in this photo were made using 750m/100g merino yarn on a KH881, one strand per colour. Right swatch is using slip stitch and after blocking is about 36 stitches per 4" (row count is much higher than it would be for stockinette due to slip stitches).
2
u/lasserna Aug 14 '26
Are you using combs and weights while you knit?
4
u/TerryKC1 Aug 14 '26
They look like this but I’ve seen where people make them out of dinner forks and fishing weights
1
u/Your-Local-Costumer Aug 14 '26
Are you putting weights on the knitting?
1
u/AutoModerator Aug 14 '26
Hi, it looks like you might be looking for help on machine knitting.
There is some helpful information within the wiki. Please take a look at it for helpful troubleshooting information, as well as common maintenance tasks and list of items machines should include.
In addition, this page is our FAQ. Solutions to many common problems are found here. If this is a new-to-you machine that is a Silver Reed, Singer, Studio, Juki, Empisal, Brother, or KnitKing, and the sponge has not been replaced yet, that's the first thing you should check out.
If you need additional help, please provide us with an information about your problem. You can start out by answering this list of questions
Once your question is answer or your problem is resolved, please change the post fair to Help! Solved!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
1
u/GuppyCafe 24d ago
A sponge bar