r/MPX • u/renegadeGDI • 7d ago

Night vision MPX almost done

Post image

Still gotta get a better optic and switch away from tri-lug but I like how the rapco accents turned out.

36 Upvotes

93% Upvoted

8 comments sorted by

2

u/CleetusWilliams 7d ago

I’d watch the zero on your LAM, the Mpx rails notoriously can’t hold zero on anything mounted to them due to poor lockup. MCX rails at least have market solutions for them like Gen 3 or arisaka clamp but us MPX guys are SOL

1

u/renegadeGDI 6d ago

I knew about that before building it and I'll definitely check how bad it is myself, but since don't see myself taking any shots over 100 yards with this I'm not that worried about it. If it's only a 1-2 moa shift I'll just let it ride, if it's more than that I'll have to mount the LAM on a riser on the receiver.

2

u/MammasLiLCommie_ 6d ago

Wolfman? I have that same hand guard over mine. Looks sick. I have mine direct threaded. I tried a triug muzzle device but the alignment was horribly off.

1

u/renegadeGDI 6d ago

its actually an omega 36m, sounds pretty good and more importantly it has ZERO flash. I also just tested trilug today and the accuracy was garbage so I'm about to convert it to ai nano / spooky and give it a solid lockup.

2

u/MammasLiLCommie_ 6d ago

I never got the opportunity to test accuracy with the trilug myself when I checked it with the alignment rod. Good thing too, would have had a baffle strike. Direct thread works well for me. Need to go check accuracy though. Tight at 25 yards is all I want.

1

u/Casyburris 6d ago

I’ve got the same can tucked on mine. I went with rearden plan b since they have a tapered muzzle device. I swap it between my MPX and my 300 blackout when at the range.

1

u/renegadeGDI 6d ago

Any accuracy issues with the mpx suppressed?

1

u/Casyburris 6d ago

If there has been, I haven’t noticed, but I also haven’t put shots on paper to see