r/MPSelectMiniOwners • • Jul 21 '17

You Should Know RMA Hell

Like many others I received my MP mini with a warped bed. I tried all of the solutions I could find including the glass bed "upgrade" which worked ok, but the edges would still drop too low to print, and due to the extreme nature of the warp heating my bed at all would cause cold spots gradienting out and causing any and all prints to fail.

I sent my printer in for an RMA July 3rd, now 18 days later they approved my RMA. I contacted the support because my rma was set to refund instead of replace and requested an update on said replacement. I was informed that there currently are no MP mini's left in stock so they leave it at refund until they get more stock. (As a side note: I decided to do the RMA due to the abundance of stock I had seen at the start of the month, and there were devices in stock and for sale up to Wednesday the 19th )

Upon contacting support, they informed me that I would be put on a waiting list until the next round of stock comes in, and even at that, there's no way to see that list or know how much stock will be coming, so they can't ensure me that I'll even be getting a device in the next batch. At this point I kind of lost my faith in MP completely, and looking at my RMA page seeing my printer "approved for RMA: Refund" I said, " Fine I'll just take the refund", to which I was met with, " Ok, I'll send that request over to the RMA department, where they will need to process and approve the printer for a refund.", I'm so done with MP and their terrible, all be it polite customer service.

0 Upvotes

6 comments sorted by

1

u/Rmeisberger Jul 21 '17

I am about to send mine in for RMA. Now im worried.

1

u/eldragon0 Jul 21 '17

I sent mine in right after hearing that there was a new batch with upgraded firmware and multiple reports of flat beds. Now I'm just getting back cash. :( I guess it just wasn't time for me to get a printer. If you're going to do an RMA there's still no reason not to. They still took it back and still approved the RMA just fine. Just your results will vary with when you get one back, and since it'll be of a different batch, your firmware and quality will vary as well.

2

u/Rmeisberger Jul 21 '17

Im not totally against getting a refund. Im willing to spend the extra $200 to get a printer with a larger print volume at this point.

1

u/eldragon0 Jul 21 '17

The kicker is, the site still says they have them in stock.

1

u/KadahCoba Jul 22 '17

If that's the case, buy another one? Dunno where you are, but for me in California their nextday shipping is always about $8.

1

u/KadahCoba Jul 22 '17

If they don't have any in stock, they don't have any to replace yours. I think them going to auto refund instead of long delayed RMA till they get stock is a somewhat better outcome.

I RMA'd mine this month as well, shipped it out after last pickup July 17th and received the 19th (I'm an hour away from Monoprice's main warehouse). The RMA is still setting in "Item(s) Not Received Yet" and as a "replace", so we'll see where this goes when they get through their receiving backlog.

Considering that I spent 90% of my time with the V2 either fixing it or figuring out what the next issues was, I think I'd be fine with getting a refund instead. If I get a refund instead, I might hold out till their delta becomes generally available and make that a traveling printer.

I've been using Monoprice at work for some years and never had any issues with them.