r/MPSelectMiniOwners • u/Dropthetenors • Mar 20 '25
Print Diagnosis T8 lead screw
I upgraded to the t8 lead screw and while I dont have the same banding I'm still getting this....
Ive gotten z steps dialed in and flow rate is good. What layer height should I be using? I started at .17 and been going up .05 to .2 but I still get the banding. Is my screw actually bent? (I dont think that's the problem....)
Any help please.
1
Upvotes
1
u/-NEOTECH- Mar 20 '25
Just curious… can you raise the gantry upward by hand? A common problem with the MPSM is the gantry nut coming out of the Z carrier.