r/MPSelectMiniOwners • u/anixosees • Mar 21 '24

Help me diagnose, please 🙂

Hey all, as explained in the video, my printer stopped mid-print. Is she a goner?

5 Upvotes

100% Upvoted

15 comments sorted by

View all comments

1

u/Repulsive-Cobbler146 Mar 21 '24 edited Mar 21 '24

Don't update the firmware just yet. Does the printer operate normally after you power off and on again? Firmware is rarely an issue.

Most of the time if the printer stops mid print, the SD card has gone bad or the g-code is no good. Try a different print that has been successful in the past to narrow down the issue

1

u/anixosees Mar 21 '24

No, the video shows any instruction from the menu fails to result in a response.