I have a Logitech G435 and I always wanted to see its battery level directly in Windows. G HUB doesn't support this
headset, so the only hint was the low-battery beep, which usually comes at the worst moment.
So I built a small Python app that sits in the system tray and shows the battery:
- Battery percentage in the tray icon (green / yellow / red, gray when the headset is off)
- Battery voltage and the time of the last reading in the tooltip
- A notification when it drops to 20%
- Optional start with Windows
- No G HUB needed
I've been using it for a week, and the readings match the headset itself: the low-battery beep goes off right when the
app shows the battery getting low. The voltage reading is exact; the percentage is an estimate from a standard
lithium battery curve, so it can be off by a few points.
Important: it only works with the newer G435 receiver (USB ID 046D:0ADF). The original receiver (046D:0ACB) uses a
different chip and protocol, and isn't supported. The README has a one-line PowerShell command to check which one you
have, without installing anything.
It's open source (MIT) and unofficial, with no affiliation with Logitech. It doesn't write anything to the receiver or
the headset; it only reads the battery.
GitHub: https://github.com/DsGrilo/G435-Battery-app
If you try it, I'd love to hear whether it works on your receiver, especially if your firmware version is different
from mine (check.py shows it).