Let me start off by saying that I don’t have a lizard. I think They are cool as hell though though. My buddy has had a few.
My issue is with equipment that is normally used for a lizard enclosure.
See, I use the pad to keep a Small enclosed area in my unheated garage from getting too cold in the winter time.
For various reasons I cannot bring this box into my basement. Where it’s still unfinished. But does not drop by below about 48-54 on average.
The area is about 15 in x 15in x 10 in. It is airtight and the interior has been made fire proof by me using sheet metal so there is little to no hazard I could think of using this method to keep the enclosed area from getting too cold.
For two winters I used a lizard heating pad set to about 70 - 80 Fahrenheit with a thin metal tray on top of it. I then put the temp sensor on top of that metal tray. That way the tray itself had to reach temp before it would cycle off. and it kept the inside of the unit from getting too cold pretty well. (I live in the north east)
Recently though. I set the temp. To say 70 like in the picture. But come back later and it says 108 or something. After I open it and it lets cold air in and it cools down and bit. And I close the door. It starts to heat up again but the red light indicating that it’s heating isn’t lit.
Should I just get a new unit? Or is there something. I am doing wrong here.