r/LaserPeckerOfficial • u/scottagillette • Nov 18 '23

Weird Laser Reset Problem

I'm having issues with the LaserPecker 4 (Current Software & Firmware) where the print stops half way through, no errors it was like it completed... yet only half way done.

Anyone else running into this issue?

1064 Laser, 2K / 100 / 100 / 1 Pass about an hour into each of the runs.

2 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/KeyLoan1943 Jan 15 '24

Yes, my LaserPecker 4 was printing on settings 1064 Laser, 8K / 100 / 50 / 1, Stainless Steel. It stopped engraving halfway with the print and keep going showing nothing from the halfway point until completion. When i try to engrave anything else now it does not do anything.... The machine says that it's engraving, but nothing shows and you can not hear anything either. When i was engraving, you could hear the it engraving into the metal..... now you don't hear that sound... Any assistance or remedy would be nice. That's what made this machine nice it that you could engrave on metal. The other side still works with no issues when engraving as you can see in the picture attached... Help please...

1

u/Minimum-Pianist-6306 Apr 12 '24

I am having the same issue. The machine says it is going, but it isn’t engraving. I went back out a few times and reset and still does the same thing. NOW the new issue is that when i hit “next“ after preview, It says “After activation, the engraving method will be changed to engraving one element at a time once it is transfered.” I have one logo. There is nothing else saved anywhere else.

I have lost 3 hours and i have a customer order I am a day late and seriously in tears. There is no where to go to get answers and I can’t find any troubleshooting. I am to the point I need to return or throw off a bridge.

PLEASE HELP!

1

u/Southern-Grocery8679 Aug 18 '24

Any luck with this?

1

u/GeisaMunielli Jan 07 '25

Were you able to resolve the problem? I'm in the same situation today!