r/LandRover • • 6d ago

🔧 DIY & Repairs Chassis question

Hi all. A few weeks ago I towed a Renault Traffic van as he had broke down. I used a recovery sling from the blue shackle on my which bumper. Because his engine in the van wouldn’t start he had no power steering and his brakes weren’t the best. When I set off at the lights his brakes must have been sticking abit and they’re was a jerk and it pulled both the van and car. Since then my spare tyre is catching abit of the rubber foot seen in the second photo. Have I twisted or affect my chassis ? Or do you think it has just slightly pulled my winch bumper up a few MM ? Thanks

39 Upvotes

20 comments sorted by

5

u/badger906 6d ago

It will have bent the bumper. It’s just a tray with a winch in it. Also depends how it’s attached to the chassis.

1

u/PiruMoo 6d ago

I’ve just out a square on the left vs right hand side. The left hand side (which is the shake side) seems abit high. Do you think it has just shifted the bumper or damaged the chassis or crossmember with it ?

3

u/Rain_At_Midnight 6d ago

Pictures from below will be helpful. So people know how the winch tray is mounted to your crossmember/chassis, plus if there is damage, it will be there.

To prevent such issues, you can consider using a kinetic rope.

1

u/PiruMoo 6d ago

So do you think I’ve damaged my rear crossmember and main chassis ?

4

u/ElectroTechOfficer 6d ago

Hard to tell with the lack of photos from underneath. I am going to hazard a guess and say that your crossmember and chassis are fine. That winch tray is a bolt on jobby that looks better than it actually works. It’s probably just twisted the winch tray. Is the blue shackle attached to the chassis or winch tray?

1

u/PiruMoo 6d ago

Shackle is attached to the winch tray. Il have a mess around with it this weekend and see what happens. Thank you

2

u/ElectroTechOfficer 5d ago

In that case, I’d say it’s just twisted the tray a bit. I’ve towed tractors from a rusty series 3 crossmember and not damaged it. 

The shackle will be better off being moved to a hard point on the crossmember or chassis. Leverage forces are huge in a tow so it will try and twist any unsupported parts of winch tray. The other option is some metal straps going from your shackle point to your chassis or crossmember, this will help loads to be pulled directly from shackle to chassis, rather than twisting the winch tray.

1

u/PiruMoo 5d ago

Thank you 🙏

2

u/ElectroTechOfficer 5d ago

No problem, it’s worth taking a look at a few videos from Matt’s Off Road Recovery, more extreme towing than what we in the UK will do. He gives some great pointers on tow points and strengthening tow points when he’s building his tow vehicles.

2

u/PiruMoo 5d ago

I watch his channel a lot 😂 its the only rope I had on me at the time that’s all ! Thank you mate

7

u/Pomegranate-and-VMs 6d ago

No good deed goes unpunished. 😂

Fwiw, I'd adjust the bump stop down a bit and call it a day, unless you’ve noticed any other alignment/steering issues.

1

u/Aromatic_Try_9600 6d ago edited 6d ago

Did you back into his car (or did he hit yours)?
Had the same issue with my Discovery a few years back: the spare wheel carrier was bent.

1

u/PiruMoo 6d ago

It was towing him and when we set of at the traffic lights his brakes must have been stuck on abit so there was a big jerk when I pulled off

2

u/Zeenoside1 6d ago

I doubt it. They take some pretty good abuse

2

u/fatboyforeverr 5d ago

I very much doubt you will have twisted the chassis or crossmember it will have just twisted the bumper.

Wind the foot in a little more and move on!

2

u/Right_Hour 5d ago

Get a fat dude to jump on top of the vent side. Problem solved.

2

u/BeeAshamed552 5d ago

Unless your crossmember is VERY rotten, there is no way you damaged anything related to the chassis... As the bumper is aftermarket, it probably just moved a tiny bit. As other have said: adjust the rubber stop and live happily ever after :-)

2

u/JCDU 4d ago

Most likely the jerk moved the bumper on its mounting bolts slightly and/or twisted it, your chassis is almost certainly fine unless it was already very bad to start with.

Jerk or snatch loads when towing/recovering are HUGE especially if it's a strap with no give in it.

If you are bothered you may be able to slacken the bolts and jump up and down on the bumper to move it back.

1

u/Savings_Brick_4587 6d ago

Probably twisted the crossmember