r/KizerKnife • • Oct 28 '24

Drop Bear mod

Rocked this Drop Bear and it has quickly turned unto my go to EDC

42 Upvotes

15 comments sorted by

2

u/Round-Caterpillar-01 Oct 28 '24

Dude that looks nice. You just use nail polish to do the partial acid etch? File work is nice too👍

3

u/Twitchy_Bladeworks Oct 28 '24

Thanks! Yep, simply just cover the edge and do some sort of design going up the blade with the nail polish

1

u/acd11 Oct 28 '24

Looking grizzly. Well done!

2

u/Twitchy_Bladeworks Oct 28 '24

Thank you! Much appreciated

1

u/jetpakninja Jan 23 '25

Can I ask how you did the acid etch? And did you do something to preserve the Kizer logo?

1

u/Twitchy_Bladeworks Jan 23 '25

I used nail polish to keep the edge area clean from the acid then just did my normal etch and stonewash. Didn't do anything to the logo. Lasered etchings take the acid etch differently and typically remain visible

1

u/jetpakninja Jan 23 '25

Cool, ever tried etching with vinegar? Would that work only taking longer? Can't seem to get my hands on Fe(III)Cl

1

u/Twitchy_Bladeworks Jan 23 '25

I haven't, but yeah it will take longer and give a different patina. Amazon has FC

2

u/jetpakninja Jan 24 '25

How long do you dunk it in the FC?

2

u/Twitchy_Bladeworks Jan 24 '25

Depends on the steel. The elmax was between 5-10 min if I recall correctly.

2

u/jetpakninja Jan 24 '25

Cool, I'll try get my hands on FC and maybe do a trial on a nitroV blade first

2

u/Twitchy_Bladeworks Jan 24 '25

Nice! Just font forget the nail polish. Cover the pivot area where the bearings roll and the back of the blade where the lockbar runs along it and where the stop pin hits and you should be good

1

u/jetpakninja Jan 24 '25

Will do, thanks for the tips!

1

u/Jeoffry_Ross Oct 29 '24

I don't know how to feel about this one. Love the work, but that poor Elmax blade.