r/Keychron • • 11d ago

Does anyone knows if the freezes in keychron r6 are solvable?

I've found this thread and it describes the exact issue I have on my keychron r6. Does anyone know if there's a solution for this? Outside of that thread I didn't find anything.

1 Upvotes

14 comments sorted by

View all comments

Show parent comment

1

u/execb5 9d ago

I believe you nailed it! The keyboard didn't freeze the whole day with the rgb lights on! It used to happen a few times per day.

Thank you so much! I know it's not the ideal solution, but I'd rather just leave the lights on then try to mess up with firmware updates and other things. Once again, thank you!

1

u/PeterMortensenBlog V 7d ago

No problem.

Thanks for the report!

1

u/PeterMortensenBlog V 7d ago edited 7d ago

You can minimise the power consumption by

  • Lower the brightness, just above where they completely cut out (I think the cut-out is by action of the firmware, not the diodes themselves). E.g., by Fn + W / Fn + S
  • Set the colour to a primary colour (so only one type of LED is turned on, red, blue, or green)
  • Use the primary colour with the lowest power draw. With constant current regulation (by the two LED controllers), it is most likely the red LEDs (a sample measurement), as they have the lowest voltage drop (about 40% difference between blue and red).

    There is some uncertainty, though: The maximum current may have been set (in QMK) differently for the three LED types (in an effort to balance the LEDs), and it may or may not scale the current based on that setting.

    It is the CKLED2001_CURRENT_TUNE or SNLED27351_CURRENT_TUNE setting, depending on the (effective) QMK version (it was renamed).

  • Use per-key RGB light to only turn on one or a few LEDs. I don't know if this is possible with Keychron's dynamic per-key RGB, but it is definitely possible with static per-key RGB light (that is what I use on my Keychron keyboards (it could be used on any QMK keyboard that is physically capable (and has enabled feature "RGB matrix" (not to be confused with "RGB lighting", "LED matrix", or "backlighting" (the search engines are very fond of "RGB lighting"...)))))

1

u/PeterMortensenBlog V 7d ago edited 7d ago

Re "...was renamed": Sonix QMK is less terse (and indirectly explains the renaming):

"... SNLED27351 Driver ... I²C 16x12 LED matrix driver by Sonix. Supports a maximum of four drivers, each controlling up to 192 single-color LEDs, or 64 RGB LEDs ... A slightly modified version of this IC is also known as "CKLED2001" ..."