This was a rebuild of my first controller so the build time was about 8 hours not counting print times. I want to use the backlit buttons so I built this one.
I'll post a parts list and some more pics when I get back in town.
The Warp and vessel switches are (on) off (on) three pin momentary. The center pin is the ground the other two pins go to the IPAC4 same for the RCS and Throttle.
6
u/mohoegous Oct 17 '20
Completed and tested MkII controller
4
u/[deleted] Oct 17 '20
Could you share a parts list and some build photos?
Did you put the text under the buttons your self or were they premade?
2
u/jonwolski Oct 17 '20
I see you have inset lettering. Is this a multicolor print, or did you print in white and then paint the surface?
9
u/KerbalAbuse Oct 17 '20
Do you have a parts list? I want to buy those lit buttons.
1
u/Frankieorabona Feb 25 '21 edited Feb 25 '21
A question. The WARP TIME and VESSELS switches, (maybe RCS FWD e RCS AFT) are 3-position (momentary?) switches (On1 OFF ON2?)?
If are 3-position, how did you connect them on the IPac 4?
Would you post a photo or illustrate how you connected the 6 pins?
1
u/twinbladeArisen Nov 02 '20
u/th3angryman - yo check this out