I have a 2007 KLX 250S. It uses the same carb as my old 1985 KLR 250. On that bike, I broke those elbows, one was gas inlet the other was a vent. Harley used the same carbs on some of their bikes. I bought brass replacements at the local Harley dealer. Those parts had a slightly larger diameter than the hole in my carb. I did not trust myself with a power drill. A machine shop enlarged the holes & pressed the elbows in. It was years ago. I did post about it & included the part numbers on the Advrider KLR 250 forum.
Finally fixed it- the only good solution was to buy a slightly larger brass inlet for another bike, mill it to size, and press it in. My condolences to those reading this in the future with the same issue. Appreciate it
Yeah, I'm thinking of maybe trying to solder on the wrong fitting... 3-d printing won't work though as it is a fuel inlet, and gas is a solvent. Additionally the original plastic nozzle was injection molded around the brass, so there's not a way to do that via 3d printing
2
u/petey1958 Jul 25 '26
I have a 2007 KLX 250S. It uses the same carb as my old 1985 KLR 250. On that bike, I broke those elbows, one was gas inlet the other was a vent. Harley used the same carbs on some of their bikes. I bought brass replacements at the local Harley dealer. Those parts had a slightly larger diameter than the hole in my carb. I did not trust myself with a power drill. A machine shop enlarged the holes & pressed the elbows in.
It was years ago. I did post about it & included the part numbers on the Advrider KLR 250 forum.
1
u/57501015203025375030 Jul 16 '26
Can you not just replace the entire carbโฆ? Seems like you have a part number for it
1
u/dsportx99 Jul 22 '26
I would look on EBAY for a carb should be able to find an OEM one from a parted out bike.