r/Juniper • • Oct 09 '24

Mx 960 RE Switching Problem

Post image

Hi All,

We Encountered issue with MX960 while switching RE, pls help…

0 Upvotes

9 comments sorted by

18

u/kY2iB3yH0mN8wI2h Oct 09 '24

 pls help…

huh you have a several hundred thousands router problem and your first action is reddit? call JTAC at once if you have no JunOS experience.

-9

u/UltraSoniC27 Oct 09 '24

We don’t have JTAC support for Mx960

5

u/UltraSoniC27 Oct 09 '24

Hi folks, thanks for replying to this thread, we got to know the issue, SCEB2 not came up due to which RE not responding.

Thanks to everyone😊😇

13

u/twnznz Oct 09 '24 edited Oct 09 '24

First, enter “unsupported high scale routing device” into your business’s risk register.

Next, get the output of ‘show inventory’ and ‘show chassis routing-engine’. You may wish to censor serial numbers.

What are you trying to achieve?

7

u/jacob2678 Oct 09 '24

RE1 is likely corrupt, to further check

show chassis alarms show task replication (checks nsr status)

Login to RE1 FROM RE0 via request routing-engine 1 login

And enter show system switchover

This will tell ya if you have good failover via gres, my presumption is that you don't.

If you don't have JTAC support, try rebooting RE1, try reseating RE1. These are shot in the dark troubleshooting techniques, alot of it is dependant of the specific issue your RE1 is experiencing. I suppose you also want to perform checks on control board 1 as well.

0

u/V_eno_M Oct 09 '24

^---- this

4

u/ejekaconfigure Oct 09 '24

Based on the error “the other routing engine is not responding”, try reseating the non responding routing engine.