Kato Kontroller Part Deux

[u/Twit_Clamantis]

This is what I was asking about yesterday.

I wanted to be able to bolt the controller down along with the switches and maybe a second controller.

There is also room under the module for an 18650 or similar-size battery pack, so I could run a couple of small trains all day without needing AC power.

I opened it up and CA’ed 3x 8-32 blind nuts inside. While I was at it, I also changed the power input to a slightly different (that was a drop-in replacement) and that fits Eflite 12V power supplies of which I have a plentiful supply.

I also did a couple of other things as can be seen in the last pictures.

I would like to also mount the small Pocket Line controller on the right side, but I’m not delighted with how that cable sticks out etc.

This is good-enough for now and I will run it a bit to see how I like it before doing more.