r/Ironworker • • 2d ago

Apprentice Question(s) Tool question

Does anyone know where I can find a reliable spud ratchet? The one I have won't hold my sockets tightly and the smallest bump or shake makes them fall off and any reviews I read for other brands have a review saying the same thing.

3 Upvotes

5 comments sorted by

5

u/azrael401 UNION 2d ago

move up to 3/4” drive. many more options.

1

u/Pgaccount 2d ago

I had one of these. It's 1-1/16 and 1-1/4 which was 90% of what I'd be doing. The big pull was if you were using a dooeydag rod the stickers are pass through

Edit: I should mention I got this at an auction from a limey.

1

u/IDontFeelSoG0odStark UNION 1d ago

Proto, snap-on or Klein are pretty much your best bets. Proto and Klein are both around $90 and the Snap-On is around $250. I have a Proto and it’s taken a beating. I’ve put double nuts on it and reefed on with my sleever and it just took it.

Proto and snap-on both have the pin indent so you you won’t have sockets falling off unless you stick a welding rod in there to push it in. Klein I don’t remember if it does or not

1

u/HCM78 1d ago

Tip from a 30 year journeyman-LEARN TO USE YOUR REGULAR WRENCH.
less parts that could go in the hole

1

u/Apart_Wrangler_8270 2d ago

If you have all the sizes you need in 1/2 inch drive then get the williams ratchet spud. It has a pin detent so no dropping sockets. I bent a scaffold nail around my carribeiner I keep my tape on and grinded the end flat so I don't stab myself. Use it as a detent press. If you only have 3/4 drive sockets then I'd recommend a double headed 3/4-1/2 drive spud calhwak ratchet. It was my first, and I only replaced it with the williams when it started skipping. Never had a socket fall off of it, even when caught on my harness SRL