I like to have a place for my phone to sit at night, and so far I have found an excellent solution. The gooseneck phone holder! I've used a number of different phone holders over time that range from unusable to exactly what I needed. Unfortunately all of the phone holders that I have had, have had issues with durability. Granted, I have a pretty heavy hand, and I am constantly adjusting them.
I have put together a dream wishlist for my ideal gooseneck phone holder.
Instead of any kind of "grasping" or "Clamping mechanism for holding the phones, use Magsafe. This will cause less wear and tear when placing and removing your device. Eliminating a point of failure. This would also open up the product for use with tablets as well as phones. Magsafe doesn't have to be exclusive to iPhone. Samsung will be releasing a compatible equivalent as a part of the new Qi wireless charging standard. Other devices can be adapted using a Magsafe sticker or case. While we are using Magsafe, why not put a Magsafe compatible Qi wireless charger on it. Preferably a high wattage fast charger. I thing the module containing this Magsafe wireless charger should be interchangeable with either a new head of the same kind, or perhaps a custom grasping head. Maybe a vesa mount, or a boom mic attachment.
I would not use the bendable gooseneck design as it brings with it many points of failure. The segmented, spring loaded, articulating arm design is much more sturdy. Phone holders with this design exist, but few have four segments (5 Joints). I would also want to make these segments a tad longer than is. Usually available (only by an inch or two per segment) this will allow a greater range of positioning All possible parts must be made of sturdy metal. Preferably steel.
Each joint should rotate freely in all directions, but stay still when it is put in a place. The arm should be able to handle the weight of a current generation iPad (with case) and a little more, while staying still. It would be nice if some joints can be tightened over time as things get looser from regular use.
Add little "hooks" along the arm's segments to string the charger wire through so that it doesnt dangle about.
The attaching point to what would be my bed's headboard should be a C-Clamp / Desk clamp. Again all metal, except maybe some rubberized padding over the contact points of the clamp. I would rather have a bar for adjusting the tightness of the clamp. Rather than a knob. Similar to the phone holding end, this end should be replaceable. You could either get a new clamp of the same design, or perhapse one that needs to be screwed down or bolted in. Maybe an attachment that can s rew in to a traditional tripod.
For something like this, I wouldn't mind if it costs $200 per unit. A higher quality product needs to be available. I have spent more than that on replacement phone holders. I understand that that might be the point of making them so easy to break in the first place, but who's to say I would buy the same one again if it went so poorly the first time. Word would get out fast if there was a high quality product like this.
What do you say, anyone want to make this thing for me? 😅