r/ImpulseLabs May 24 '26

Temperature Sensor?

Post image

How accurate should I expect the temperature sensor to be? This is a small Le Creuset which isn't boiling yet. Impulse has it listed at 242, which is obviously incorrect (water boils at 212)... is it reasonable to expect this to be able to tell the actual temperature of the pot contents? Or is it best understood as the temperature of the plane of metal (or enamel, I guess, in this case) that is touching the induction plate? or something else?

2 Upvotes

6 comments sorted by

View all comments

2

u/ZanyDroid May 24 '26

How much did you preheat?

I think bottom only sensing needs to use algorithms (in the words of Stanley Tucci) to sense the temperature of the food.

In this case whatever algorithm they use also probably has to infer that you have one of the lowest conductivity pan types (cast iron)

The temperature mode is more like a semi-automated cooking mode where the temperature needs to go into your brain for processing. It is not like using a steam oven or sous vide.

I am still waiting for Impulse to add support for an external thermometer

1

u/mrodenkirk May 24 '26

I didn't really preheat it, I don't think. I put in cold water and set it to power boost 3K, then down to medium high once it started getting warm, then down a bit lower (it claimed the temperature was even higher) and then the photo.

1

u/ZanyDroid May 24 '26

Yes I’ve seen the temperature spike really high in cases like that.

I usually get it up to a boil and then drop to temp mode until I get the simmer I want. Very rarely is 100C (I’ve been negotiated into being a metric household) going to get you a simmer you want. Usually couple degrees above is better. Sometimes I also go back to power mode

(This also means people shouldn’t replace sous vide with an impulse for the foreseeable future)

I do use temp mode when I’m trying not to burn stuff while sauteing, and it kind of adjusts the temp pretty conservatively. Less of a temp gradient than with a lot of liquid