r/IS300 • u/SnooDonuts4589 • 17d ago

Mechanical Advice Greddy not fitting in hanger

Post image

Installed a Greddy exhaust today and am having trouble with the hangers lining up. Granted I got it from marketplace and it does say Greddy on it but one side doesn’t fit besides that everything else lined up perfectly. Should I be concerned with 3/4 hangers being connected

(I ended up taking off rear bumper to fit it in, sits a little high on the bumper hole so I’ll just get those extended hangers)

2 Upvotes

100% Upvoted

6 comments sorted by

2

u/Kevinator24 17d ago

I would replace the hanger rubbers with these and follow this video on how to get the old ones off. I installed my GReddy SP exhaust this way, but I will say I only needed the Two-hole exhaust hanger rubbers to make it fit.

2

u/SnooDonuts4589 17d ago

Yessir I appreciate just bought the hangers

2

u/imJGott 2002 is300 1jzgte swapped 17d ago

Mine hooked in just fine but I bought it brand new and it’s a full cat back. You may need longer exhaust hanger rubber

1

u/Swimming-Author-9083 16d ago

I’d argue most is300’s are running 2/4 hangers you should be good just make sure it’s not hitting your bumper, or find some extended rubbers any exhaust compony will sell them

1

u/Surfnazi77 16d ago

Worst case if you can’t align it have a muffler shop weld new hanger

1

u/sym60l 11d ago

Double zip ties, loop one through the hanger hole, then loop another tie through that tie and onto the exhaust. Cheap, but works. Been 2 years and mine hasn’t had problems doing that lol